Hyundai Equus Manuals

Hyundai Azera: TPMS Receiver Description and Operation - Tire Pressure Monitoring System - Suspension System - Hyundai Azera 2011-2025 Service ManualHyundai Azera: TPMS Receiver Description and Operation

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Suspension System / Tire Pressure Monitoring System / TPMS Receiver Description and Operation

Description

1.
Mode
(1)
Virgin State
A.
The receiver as a sole part is shipped in this state. Replacement parts should therefore arrive in this state.
B.
In this state, there is no Auto-Location, no sensor wake-up, no sensor monitoring and no DTC monitoring..
C.
The state indicates that platform specific parameters must be written to the receiver and that sensors are un-learned.
(2)
Normal State
A.
In order for tire inflation state and DTC monitoring to occur, the receiver must be in this state.
B.
In this state, automatic sensor location / learning is enabled.
2.
Overview
A.
Sends LF command data to initiators.
B.
Controls sensor state:
Ignition on - Normal Delayed
Ignition off - Storage.
C.
Auto-Locates sensors.
D.
Auto-Learns new sensors.
E.
Receives RF data from sensor.
F.
Uses sensor data to decide whether to turn on TREAD Lamp / wheel location LED's.
G.
Uses sensor information, distance traveled, background noise levels, Auto-learn status, short circuit output status, vehicle battery level, internal receiver states to determine if there is a system or a vehicle fault.
TPMS Sensor Repair procedures
Removal 1. Remove the tire. (Refer to Tires/Wheels - "Tire") 2. Remove the valve nut.     The valve nut should not be re-used. Installation Sensor Fit   & ...

TPMS Receiver Schematic Diagrams
Circuit Diagram Connector pin number Pin NO.DiscriptionRemark1IGN2CAN_Low3-4Battery5CAN_High6Ground ...

See also:

Troubleshooting
Troubleshooting SymptomSuspect areaEngine will not start or stuggle to startVapor hose damaged or disconnectedEngine stuggle to startMalfunction of the Purge Control Solenoid ValveRough idle or e ...

Accelerator Pedal Repair procedures
Removal 1. Turn the ignition switch OFF and disconnect the negative (-) battery cable. 2. Disconnect the accelerator position sensor connector (A). 3. Remove the installation nuts (B) and ...

Overdrive Clutch Control Solenoid Valve(OD/C_VFS) Repair procedures
Inspection 1. Turn ignition switch OFF. 2. Disconnect the solenoid valve connector. 3. Measure resistance between sensor signal terminal and sensor ground terminal. 4. Check that the ...

Categories

Hyundai Azera Manuals


© 2011-2025 Copyright www.hgmanual.com