Hyundai Azera: Hazard warning flasher

The hazard warning flasher should be used whenever you find it necessary to stop the car in a hazardous location. When you must make such an emergency stop, always pull off the road as far as possible.
The hazard warning lights are turned on by pushing in the hazard switch. This causes all turn signal lights to blink. The hazard warning lights will operate even though the key is not in the ignition switch.
To turn the hazard warning lights off, push the switch a second time.
Rearview camera (If equipped)
LightingHeater & A/C Control Unit(Full Automatic) Repair procedures
Inspection
Self diagnosis
1.
Self-diagnosis process
2.
How to read self-diagnostic code.
After the display panel flickers three times every 0.5
second, the corresponding fault code flicker ...
Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the hole plug (B).
3.
After loosening the mounting bolt, then remove the rear door outside hand ...
Refrigerant line Components and Components Location
Component Location
...