Hyundai Azera: Line Pressure Control Solenoid Valve Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Line Pressure Control Solenoid Valve Description and Operation
| Description |
Line Pressure(L/P) control solenoid valve is attached to the
valve body. This variable force solenoid valve directly controls the
hydraulic pressure inside the line pressure.
26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Line Pressure Control Solenoid Valve Specifications
Specifications
Direct control VFS[LINE Pressure]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)]500.14 ~ 9.81(5.1~ 0.1, 72.54 ~ 1.42)Current value(mA)50 ~ 850 Inter ...
See also:
Rear Door Outside Handle Repair procedures
Replacement
1.
Remove the rear door trim.
(Refer to Rear Door - "Rear Door Trim")
2.
Remove the hole plug (B).
3.
After loosening the mounting bolt, then remove the rear door outside hand ...
General Information
Important Safety Notice
Proper service methods and repair procedures are essential
for safe, reliable operation of all motor vehicles as well as personal
safety of the operator. The service pro ...
Rear Seat Belt Buckle Repair procedures
Replacement
1.
Remove the rear seat cushion assembly.
(Refer to Rear Seat - "Rear Seat Assembly")
2.
Loosen the mounting bolt, and then remove the rear seat belt buckle (A).
[LH]
Tighten ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com