Hyundai Equus Manuals

Hyundai Azera: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures - Automatic Transaxle Control System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: 26 Brake Control Solenoid Valve(26/B_VFS) Repair procedures

Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the resistance is within the specification.
Removal
   
Replacing an on/off solenoid valve (SS-A, SS-B) does not require additional hydraulic pressure adjustment; however, the hydraulic pressure will need to be adjusted after replacing the VFS solenoid valve. If replacing the VFS solenoid valve; also replace the valve body assembly.
(Refer to Hydraulic System - "Valve Body")
26 Brake Control Solenoid Valve(26/B_VFS) Schematic Diagrams
Circuit Diagram ...

Line Pressure Control Solenoid Valve Description and Operation
Description Line Pressure(L/P) control solenoid valve is attached to the valve body. This variable force solenoid valve directly controls the hydraulic pressure inside the line pressure. ...

See also:

Steering wheel audio control
The steering wheel audio control button is installed to promote safe driving. Do not operate audio remote control buttons simultaneously. VOLUME (VOL +/-) (1) Push up the lever to increase v ...

Heater & A/C Control Unit(Full Automatic) Repair procedures
Inspection Self diagnosis 1. Self-diagnosis process 2. How to read self-diagnostic code. After the display panel flickers three times every 0.5 second, the corresponding fault code flicker ...

CVVT Assembly Repair procedures
Removal 1. Remove the timing chain. (Refer to Timing System - "Timing Chain") 2. Remove the CVVT assembly. A. A: LH exhaust CVVT B. B: LH intake CVVT C. C: RH intake CVVT D. D: ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com