Hyundai Azera: Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Automatic Transaxle System / Automatic Transaxle Control System / Torque Converter Control Solenoid Valve (T/CON_VFS) Description and Operation
| Description |
Torque converter control solenoid valve (T/CON) is attached
to the valve body. This variable force solenoid valve directly controls
the hydraulic pressure inside the torque converter.
Output Speed Sensor Repair procedures
Inspection
1.
Check signal waveform of Input & output speed sensor using the GDS.
Specification: Refer to "Signal Wave Form" section.
Removal
1.
Remove the battery and the battery ...
Torque Converter Control Solenoid Valve (T/CON_VFS) Specifications
Specifications
Direct control VFS[T/CON]
? Control type : Normal low type
Control Pressure [kpa (kgf/cm?, psi)] 9.81~ 500.14 (0.1~ 5.1, 1.42 ~ 72.54)Current value(mA)50 ~ 850 Internal res ...
See also:
Tie-down hook
WARNING - Tie-down hook
Do not use the tie-down hooks for towing purposes. These hooks are designed
ONLY for transport tie-down. If the tiedown hooks are used for towing, the tie-down
hooks or defl ...
Oil Filter Body Repair procedures
Removal and Installation
1.
Remove the water pipe.
(Refer to Cooling System - "Water Pipe")
2.
Wait for 5 minutes after loosening the oil filter cap to drain well the oil in the oil filter.
...
Repair procedures
General Inspection
After or before servicing the EPS system, perform the
troubleshooting and test procedure as follows. Compare the system
condition with normal condition in the table below and ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com