Hyundai Azera: Trunk Lid Latch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Trunk Lid / Trunk Lid Latch Repair procedures
| Replacement |
|
| 1. |
Remove the trunk lid trim.
(Refer to Trunk Lid - "Trunk Lid Trim") |
| 2. |
Disconnect the trunk lid latch connector (A). |
| 3. |
Disconnect the cable (B), then loosen the latch assembly (C) mounting bolts and remove.
|
| 4. |
Installation is the reverse of removal.
|
Trunk Lid Latch Components and Components Location
Component Location
1. Trunk lid latch
...
Trunk Lid Key Holder Components and Components Location
Component Location
1. Trunk lid key holder
...
See also:
Filler-Neck Assembly Repair procedures
Removal
1.
Lift the vehicle.
2.
Disconnect the fuel filler hose (A).
3.
Disconnect the ventilation hose (B) from the fuel tank air filter.
4.
Open the fuel filler door and then remove ...
Rear Hub - Carrier Repair procedures
Replacement
1.
Loosen the wheel lug nuts slightly.
Raise the vehicle, and make sure it is securely supported.
2.
Remove the rear wheel and tire (A) from front hub.
Tightening torque:
88. ...
Rail Pressure Sensor (RPS) Repair procedures
Inspection
1.
Connect the GDS on the Data Link Connector (DLC).
2.
Measure the output voltage of the RPS at idle and various engine speed.
ConditionOutput Voltage (V)Idle Approx. 1.21, ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com