Hyundai Equus Manuals

Hyundai Azera: Valve Body Repair procedures - Hydraulic System - Automatic Transaxle System - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Valve Body Repair procedures

Removal
1.
Remove the battery and the battery tray.
2.
Remove the under cover (A).

Tightening torque:
7.8 ~ 11.7 N.m (0.8 ~ 1.2 kgf.m, 5.7 ~ 8.6 lb-ft)

3.
Replace new gasket and the plug after draining the automatic transaxle fluid by removing the drain plug.
(Refer to Hydraulic System - "Fluid")
4.
Remove the valve body cover (B) and eyebolt (A).

Tightening torque:
(A) 4.9 ~ 5.9 N.m (0.5 ~ 0.6 kgf.m, 3.6 ~ 4.3 lb-ft)
(B) 13.8 ~ 14.7 N.m (1.3 ~ 1.5 kgf.m, 9.4 ~ 10.8 lb-ft)

   
Always replace the gasket of the eyebolt use new one whenever loosening eyebolt.

5.
Remove the bolt (3ea) after disconnecting the solenoid valve connector (B) and the oil temperature sensor connector (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

6.
Remove the valve body assembly (A).

Tightening torque:
9.8 ~ 11.8 N.m (1.0 ~ 1.2 kgf.m, 7.2 ~ 8.7 lb-ft)

Installation
1.
Installation is the reverse of removal.
   
After replacement or reinstallation procedure of the valve body assembly, must perform procedures below.
   
•
Check fluid level after fill the automatic transaxle with fluid.
(Refer to Hydraulic System - "Fluid")
•
Perform Transaxle Control Module(TCM) learning after replacing the valve body to prevent slow transaxle response, jerky acceleration and jerky startup.
(Refer to Automatic Transaxle Control System - "Repair procedures")
•
Replace the gasket (A) before reinstalling valve body cover.

Valve Body Components and Components Location
Components Location 1. PCV adjust screw2. Solenoid valve3. Oil temperature sensor4. Accumulator5. Low & reverse brake(LR/B) pressure flow hole6. Under drive brake (UD/B) pressure flow hole ...

Clutch & Brake
...

See also:

Components and Components Location
Components Rear Seat Back [RH] 1. Headrest2. Headrest guide3. Rear seat back pad4. Rear seat back cover5. Rear seat back pad support wire6. Rear back armrest7. Hinge bracket cover8. Rear seat ...

In-car sensor Repair procedures
Inspection 1. Ignition "ON" 2. Blow warm air into the in-car sensor air inlet. Measure sensor resistance between 2 and 4 terminals. 1. Incar Motor(-)2. Sensor GND3. -4. Incar Sensor (+)5. - ...

Air Ventilation Seat Repair procedures
Removal [Front Seat] 1. Remove the front seat assembly. (Refer to Body - "Front Seat Assembly") 2. Remove the seat back cover and cushion cover. (Refer to Body - "Front Seat Cushion Cover") ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com