Hyundai Azera: Windshield wipers
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Owners Manual / Features of your vehicle / Wipers & Washers / Windshield wipers
Operates as follows when the ignition switch is turned ON.
MIST :
For a single wiping cycle, move the lever to the MIST position and release it with the lever in the OFF position. The wipers will operate continuously if the lever is held in this position.
OFF :
Wiper is not in operation.
INT :
Wiper operates intermittently at the same wiping intervals. Use this mode in a light rain or mist. To vary the speed setting, turn the speed control knob.
LO :
Normal wiper speed
HI :
Fast wiper speed
Windshield wiper/washer
A :Wiper speed control
MIST – Single wipe
OFF – Off
INT – Intermittent wipe
LO – Normal wiper speed
HI – Fast wiper speed
B : Intermittent wipe time adjustment
C :Wash with b ...
Windshield washers
In the OFF position, pull the lever gently toward you to spray washer fluid on
the windshield and to run the wipers 1-3 cycles.
Use this function when the windshield is dirty.
The spray and wip ...
See also:
Torque Converter Control Solenoid Valve (T/CON_VFS) Repair procedures
Inspection
1.
Turn ignition switch OFF.
2.
Disconnect the solenoid valve connector.
3.
Measure resistance between sensor signal terminal and sensor ground terminal.
4.
Check that the ...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Windshield Wiper-Washer Switch Repair procedures
Inspection
1.
The windshield wiper / washer switch inputs can be checked using the GDS.
2.
To check the input value of windshield wiper/washer switch, select option "MFSW".
3.
To consult t ...
Categories
Hyundai Azera Manuals
