Hyundai Equus Manuals

Hyundai Azera: Hood Latch Release Handle Repair procedures - Hood - Body (Interior and Exterior) - Hyundai Azera 2011-2026 Service ManualHyundai Azera: Hood Latch Release Handle Repair procedures

Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body (Interior and Exterior) / Hood / Hood Latch Release Handle Repair procedures

Replacement
1.
Using a screwdriver or remover, remove the hood release handle (A).
   
•
Use a 6mm hex bit to press the center until the handle easily pulls off the post.

2.
Installation is the reverse of removal.
   
•
Make sure the hood latch cable is connected properly.
•
Make sure the hood locks/unlocks and opens/closes properly.
Hood Latch Release Handle Components and Components Location
Component Location 1. Hood latch release handle ...

Hood Latch Components and Components Location
Component Location 1. Hood latch ...

See also:

Components and Components Location
Components 1. Steering column2. ECU3. Motor4. Steering gear box ...

Engine Control Module (ECM) Repair procedures
Removal     When replacing the ECM, the vehicle equipped with the immobilizer must be performed procedure as below. [In the case of installing used ECM] 1. Perform "ECM Neutr ...

Front Strut Assembly Components and Components Location
Components 1. Dust cover2. Upper locking nut3. Self locking nut4. Space5. Insulator6. Spring upper seat7. Spring upper pad8. Strut dust cover & Bumper rubber9. Coil spring10. Spring lower pad ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com