Hyundai Azera: Smart key unit Components and Components Location
| Component (1) |

| Pin | Connector A | Connector B | Connector C | Connector D |
| 1 | Power GND1 | ACC | RF data | Antenna power - LH |
| 2 | Power GND2 | IGN2 | C CAN low | Antenna power - RH |
| 3 | - | Stop lamp fuse | B CAN low | Antenna power - Bumper |
| 4 | Starter relay | Driver toggle button | Immobilizer | Antenna power - Trunk |
| 5 | Vbat CPU | Assist toggle button | Demodulator power | Antenna power - Interior1 |
| 6 | Vbat Load | RPM | ESCL enable | Antenna power - Interior2 |
| 7 | ESCL GND | Wheel speed | SSB ACC LED | - |
| 8 | SSB illumication GND | - | SSB IGN LED | - |
| 9 | - | - | - | Antenna GND - LH |
| 10 | ACC relay | R position | - | Antenna GND - RH |
| 11 | IGN2 relay | - | C CAN hi | Antenna GND - Bumper |
| 12 | IGN1 relay | IGN1 | B CAN hi | Antenna GND - Trunk |
| 13 | SSB illumication Power | Start feedback | Immobilizer TXCT | - |
| 14 | ESCL battery | Stop lamp switch | EMS COM | - |
| 15 | - | ESCL COM | Antenna GND - Interior1 | |
| 16 | - | - | Antenna GND - Interior2 | |
| 17 | SSB1 | - | - | |
| 18 | SSB2 | RF enable | - | |
| 19 | - | Demodulator GND | ||
| 20 | - | SSB OFF LED | ||
| 21 | - | |||
| 22 | - | |||
| 23 | - | |||
| 24 | ESCL unlock |
Smart key Repair procedures
Smart key unit Schematic DiagramsReceiver-Drier Repair procedures
Replacement
1.
Remove the condenser, and then remove the bottom cap (B) with L wrench (A) from the condenser.
Tightening torque :
9.8~14.7N.m (1.0~1.5kgf.m, 7.2~10.8 lb-ft)
2.
Remove ...
Water Temperature Control Assembly Components and Components Location
Components
1. Water temperature control assembly2. Throttle body water hose3. Gasket
...
Using a child restraint system
For small children and babies, the use of a child seat or infant seat is required.
This child seat or infant seat should be of appropriate size for the child and should
be installed in accordance ...