Hyundai Azera: Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Front Back view camera System / Description and Operation
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Body Electrical System / Front Back view camera System / Description and Operation
| Description |
Front blind camera is a supplemental system that shows blind spot in front of the vehicle through the AV monitor.
The front blind camera will operate when you push the button
and shift the transaxle into N(Neutral) or D(Drive) while driving less
then 10km/h. After the vehicle stops for 4 minutes with the transaxle in
N(Neutral) or D(Drive), it will bring up the previous screen.
Back view camera will activate when the backup light is ON
with the ignition switch ON and the shift lever in the REVERSE position.
This system is a supplemental system that shows behind the vehicle through the AV monitor while backing-up.
This system is a supplementary function only. It is the
responsibility of the driver to always check the inside/ outside
rearview mirror and the area behind the vehicle before and while backing
up because there may be blind spot that can't be seen by the camera. |
Schematic Diagrams
Circuit Diagram
...
Repair procedures
Removal
Front View Camera
1.
Remove the front bumper.
(Refer to Body - "Front Bumper Cover")
2.
Loosen 3 screws and disconnect the connector(6 pins). Remove the front view camera(A).
Back ...
See also:
Telematics Unit (TMU) Components and Components Location
Component
...
Smart Cruise Control Unit Schematic Diagrams
Circuit Diagram
...
Storing positions into memory using the buttons on the door
Storing driver’s seat positions
1. Shift the shift lever into P (Park) while the ignition switch is ON.
2. Adjust the driver’s seat, outside rearview mirror, steering wheel position and
instrum ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com