Hyundai Azera: Engine Room Under Cover Repair procedures

Fifth generation HG (2011–2025) / Hyundai Azera 2011-2025 Service Manual / Engine Mechanical System / Engine And Transmission Assembly / Engine Room Under Cover Repair procedures

Removal and Installation

1.

Remove the engine room under cover (A) and (B).

Tightening torque:

7.8 ~ 11.8 N.m (0.8 ~ 1.2 kgf.m, 5.8 ~ 8.7 lb-ft)

•	When removing the under cover (B), unfasten the mounting bracket bolts and then remove the under cover and mounting bracket assembly.

2.	Installation is reverse order of removal

Engine Room Under Cover Components and Components Location

Components 1. Engine room front under cover2. Engine room RH Under cover3. Engine room LH Under cover ...

Engine Mounting Components and Components Location

Components 1. Transaxle mounting bracket2. Roll road bracket3. Sub frame4. Engine mounting bracket5. Engine mounting support bracket ...

See also:

Using Voice Recognition
Starting Voice Recognition Shortly press the key on the steering wheel remote controller. Say a command. If prompt feedback is in [ON], then the system will say “Please say a command after the ...

Camshaft Position Sensor (CMPS) Repair procedures
Inspection 1. Check the signal waveform of the CMPS and CKPS using the GDS. Specification: Refer to “Wave Form” Removal • DON'T remove the camshaft position se ...

Shift Cable Components and Components Location
Components 1. Shift lever knob2. Shift lever assembly 3. Control cable assembly4. Manual control lever (T/M side) ...

Categories

Hyundai Azera Manuals

© 2011-2025 Copyright www.hgmanual.com