Hyundai Equus Manuals

Hyundai Azera: TJ Joint Components and Components Location - Driveshaft Assembly - Driveshaft and axle - Hyundai Azera 2011-2026 Service ManualHyundai Azera: TJ Joint Components and Components Location

Components
[LH]

1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
13. Circlip

[RH]

1. BJ assembly
2. Circlip
3. BJ boot band
4. BJ boot
5. Dynamic damper band
6. Dynamic damper
7. Shaft
8. TJ boot band
9. TJ boot
10. Spider assembly
11. Snap ring
12. TJ case
13. Circlip

Front Driveshaft Repair procedures
Replacement 1. Loosen the wheel lug nuts slightly. Raise the vehicle, and make sure it is securely supported. 2. Remove the front wheel and tire (A) from front hub. Tightening torque: 88. ...

TJ Joint Repair procedures
Replacement     • Special grease must be applied to the driveshaft joint. Do not substitute with another type of grease. • The boot band should be replaced with a ne ...

See also:

Description and Operation
Description The ECM (Electro Chromatic inside rear view Mirror) is for dimming the reflecting light from a vehicle behind at night, in order the user not to be dazzled by the light. The forward ...

Brake Line Components and Components Location
Components ...

Accelerator Position Sensor (APS) Description and Operation
Description Accelerator Position Sensor (APS) is installed on the accelerator pedal module and detects the rotation angle of the accelerator pedal. The APS is one of the most important sensors ...

Categories

Hyundai Azera Manuals

© 2011-2026 Copyright www.hgmanual.com