Hyundai Azera: Water Temperature Control Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures
Fifth generation HG (2011–2026) / Hyundai Azera 2011-2026 Service Manual / Engine Mechanical System / Cooling System / Water Temperature Control Assembly Repair procedures
| Removal and Installation |
| 1. |
Remove the radiator upper hose and lower hose.
(Refer to Cooling System - "Radiator Hose") |
| 2. |
Disconnect the throttle body water hoses.
|
| 3. |
Disconnect the heater hoses.
(Refer to Cooling System - "Heater Hose") |
| 4. |
Disconnect the WTS & gauge unit connector (A)
|
| 5. |
Separate the engine wiring protector mounted on the water temperature control assembly.
|
| 6. |
Remove the water temperature control assembly (A) and the gaskets.
|
| 7. |
Install in the reverse order of removal. |
Water Temperature Control Assembly Components and Components Location
Components
1. Water temperature control assembly2. Throttle body water hose3. Gasket
...
Water Pipe Components and Components Location
Components
1. Water center pipe2. O-ring
...
See also:
ETC (Electronic Throttle Control) System Troubleshooting
Fail-Safe Mode
ItemFail-SafeETC MotorThrottle valve stuck at 7°TPSTPS 1 faultECM looks at TPS2TPS 2 faultECM looks at TPS1TPS 1,2 faultThrottle valve stuck at 7°APSAPS 1 faultECM looks at APS 2 ...
Alignment Repair procedures
Front Wheel Alignment
When using a commercially available computerized wheel
alignment equipment to inspect the front wheel alignment, always
position the vehicle on a lev ...
Intake Air Temperature Sensor (IATS) Repair procedures
Inspection
1.
Turn the ignition switch OFF.
2.
Disconnect the IATS connector.
3.
Measure resistance between the IATS terminals 3 and 4.
4.
Check that the resistance is within the speci ...
Categories
Hyundai Azera Manuals
© 2011-2026 Copyright www.hgmanual.com